Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
large deformation of cantilever - module selection
Posted 18 avr. 2024, 03:09 UTC−4 MEMS & Piezoelectric Devices, Structural Mechanics Version 6.2 0 Replies
Please login with a confirmed email address before reporting spam
I would like to model a cantilever consisting of three layers. Of silicon, aluminum and nickel. Of which nickel will not be along the entire length of the cantilever. The force will act on the same section as the nickel. I am interested in very high deformation. With what module it is best to model this. Is Solid mechanics ok, for this task? I tried to make a larger deformation in the plate model deflected by magnet. And there were problems with it. Is solid mechanics suitable for large deformations?
Hello Michal Herbko
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.