Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
calculate the radius of curvature in 2D model
Posted 21 déc. 2012, 07:33 UTC−5 1 Reply
Please login with a confirmed email address before reporting spam
Dear colleaugues,
I was looking for ways of calculating the radius of curvature of a deforming boundary in 2D model (in time dependent solid mechanics module).
i tried to use the equations derived for two fucntions of time i.e. u = u(t) and v=v(t) ,
Rad of curv = ((ut^2+vt^2)^1.5 )/(ut*vtt +vt*utt)
but this equation give me very noisy values which are bad for my solver. do u have any other suggestion to deal with this kind of problem?
Thanking you in advance
I was looking for ways of calculating the radius of curvature of a deforming boundary in 2D model (in time dependent solid mechanics module).
i tried to use the equations derived for two fucntions of time i.e. u = u(t) and v=v(t) ,
Rad of curv = ((ut^2+vt^2)^1.5 )/(ut*vtt +vt*utt)
but this equation give me very noisy values which are bad for my solver. do u have any other suggestion to deal with this kind of problem?
Thanking you in advance
1 Reply Last Post 21 déc. 2012, 09:56 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
the noise comes from your higher order derivatives, try increasing the discretization order by "1", and use fine time steps.
Anyhow this has been discussed a few times on the Forum the last 2-3 years, so if you search you should find back the explanations on how to ;), I do not remember like that
--
Good luck
Ivar
the noise comes from your higher order derivatives, try increasing the discretization order by "1", and use fine time steps.
Anyhow this has been discussed a few times on the Forum the last 2-3 years, so if you search you should find back the explanations on how to ;), I do not remember like that
--
Good luck
Ivar