Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to change equation during a transient solution in V4.3

Posted 4 déc. 2012, 09:48 UTC−5 Chemical Reaction Engineering Version 4.3a 2 Replies

Piyaporn Sriniang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everybody,

I am simulating a transient solution by using transport of dilute species. I would like to change the equation during a transient solution and use the initial value of simulation 2 from last time step of simulation 1, please help me.

The methodology I use is :
1. I run simulation 1 with the equation 1, 3, 4, 5 and 6
2. I run simulation 2 with the equation 2, 3, 4, 5 and 6

How to do it ?

Thank you very much.
Piyaporn


2 Replies Last Post 4 déc. 2012, 14:35 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 4 déc. 2012, 14:01 UTC−5
Hi

check the doc on the solvers, and the tabs for solver initial values ("Values of Dependent variables"), and get those of study 2 to point to study 1

or if both sequences are under the same study1, then get step2 to point to step1

Then use the step tab "Physics and Variables" selection to disable enable the desired BCs
--
Good luck
Ivar
Hi check the doc on the solvers, and the tabs for solver initial values ("Values of Dependent variables"), and get those of study 2 to point to study 1 or if both sequences are under the same study1, then get step2 to point to step1 Then use the step tab "Physics and Variables" selection to disable enable the desired BCs -- Good luck Ivar
Piyaporn Sriniang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 4 déc. 2012, 14:35 UTC−5
Thank you very much Ivar

Thank you very much Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content