Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Saving the last iteration of topology optimisation

Posted 27 sept. 2023, 11:03 UTC−4 1 Reply

Dehlia Menger
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear,

For my project, I plan to perform an analysis on the final iteration of the topology optimization, where the geometry obtained from this last iteration will serve as the basis for the analysis. How can I do this? Is it possible to save the result of the topology optimisation in a new model and then do analysis?

Thank you in advanced!

With kind regards, Dehlia

1 Reply Last Post 2 oct. 2023, 04:11 UTC−4
Acculution ApS Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 year ago 2 oct. 2023, 04:11 UTC−4

2D or 3D? Which physics is it?

-------------------
René Christensen, PhD
Acculution ApS
www.acculution.com
info@acculution.com
2D or 3D? Which physics is it?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content