Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simple 2D reflectance measurement

Posted 20 juil. 2023, 04:37 UTC−4 1 Reply

Victoria Madeleine Bjelland
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello!

I am trying to create a simple 2D measurement based on a 3D one I saw documented. However, I am dividing by 0 somewhere and cannot figure out where that is.

All help is appreaciated.

-Victoria

Attachments:

1 Reply Last Post 20 juil. 2023, 05:21 UTC−4
Acculution ApS Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 year ago 20 juil. 2023, 05:21 UTC−4

I don't have the proper module, but opening the file I saw that one of your ports has a field in the x-direction while the other is in y. It would seem that the error message has something to do with the port, so try disabling them and run again to see if there are any errors. If not, then you know where to debug.

-------------------
René Christensen, PhD
Acculution ApS
www.acculution.com
info@acculution.com
I don't have the proper module, but opening the file I saw that one of your ports has a field in the x-direction while the other is in y. It would seem that the error message has something to do with the port, so try disabling them and run again to see if there are any errors. If not, then you know where to debug.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content