Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

More time for transient simulation

Posted 27 févr. 2023, 04:42 UTC−5 Mesh, Results & Visualization, Physics Interfaces Version 5.6 1 Reply

Arunjith T
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everyone, I am doing a simulations on flow past a rotating slippery cylinder. After user controlled meshing, there are 56k quadrilateral elements and solution needs 1.5day to complete. Physics controlled meshing gives even more number of triangular elements but the simulation only takes 2-3 hours. A time step of 0.025 upto 80s are the conditions. What could be the cause of time delay for the simulations? Could that be due to solver settings (Used solver is PARADISO).

1 Reply Last Post 27 févr. 2023, 11:14 UTC−5
Dave Greve
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago 27 févr. 2023, 11:14 UTC−5

Questions you should ask yourself:

  1. Are the solutions significantly different?
  2. Does the user-controlled mesh include a Boundary Layers step?
  3. Can I post a reduced model to get more useful advice?
Questions you should ask yourself: 1. Are the solutions significantly different? 2. Does the user-controlled mesh include a Boundary Layers step? 3. Can I post a reduced model to get more useful advice?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content