Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Is there any model about performing transient analysis using Joule heating and thermal expansion physics in COMSOL4.2?
Posted 25 sept. 2012, 20:31 UTC−4 Low-Frequency Electromagnetics, Heat Transfer & Phase Change, Structural Mechanics Version 4.2 2 Replies
Please login with a confirmed email address before reporting spam
I tried transient solver on the Joule heating and thermal expansion physics in COMSOL4.2. My geometry is just a simple beam with injecting current at one port and ground at the other. There is always a error "Failed to evaluate the variable mod1.tem.DZ". But the problem is gone when I used just joule heating physics or thermal stress physics. Is there anything I need to notice when transient solver is used on the Joule heating and thermal expansion physics? Is there any model available? Thanks.
James
Please login with a confirmed email address before reporting spam
The problem you described has been solved in version 4.2a update 2. Please contact your local Comsol distributor to obtain a copy of the latest version (4.3). If you are using a university license, you may want to speak to your professor instead.
--
Andrea Ferrario
Electromagnetics Group
COMSOL AB
Please login with a confirmed email address before reporting spam
Hello James,
The problem you described has been solved in version 4.2a update 2. Please contact your local Comsol distributor to obtain a copy of the latest version (4.3). If you are using a university license, you may want to speak to your professor instead.
--
Andrea Ferrario
Electromagnetics Group
COMSOL AB
OK. Thanks a lot.
James