Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to draw a half circle ??

Posted 21 sept. 2012, 04:07 UTC−4 Low-Frequency Electromagnetics Version 4.2a 2 Replies

Muthuraman Chinnadurai
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi Friends,
can you help me to draw a half circle of radius 35mm.

Thanks in advance.
2 Replies Last Post 21 sept. 2012, 05:13 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 21 sept. 2012, 04:45 UTC−4
Hi

you have three ways:

1) draw the full circle, draw a box covering the half, subtract the box from the full circle.
2) insert the shape with the Bezier curves, you need to check the doc to get the correct sqrt(2) value in the right place
3) draw with freehand, via Bezier using the grid placed on the radius as help points

--
Good luck
Ivar
Hi you have three ways: 1) draw the full circle, draw a box covering the half, subtract the box from the full circle. 2) insert the shape with the Bezier curves, you need to check the doc to get the correct sqrt(2) value in the right place 3) draw with freehand, via Bezier using the grid placed on the radius as help points -- Good luck Ivar
Magnus Ringh COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 21 sept. 2012, 05:13 UTC−4
Hi,

Another option is to set the Section angle to 180 degrees in the settings window for the Circle geometry object.

Best regards,
Magnus Ringh, COMSOL
Hi, Another option is to set the Section angle to 180 degrees in the settings window for the Circle geometry object. Best regards, Magnus Ringh, COMSOL

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content