Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

CIR coupling to pzd

Please login with a confirmed email address before reporting spam

Hello,

I'm trying to couple a piezoelectric model with an electrical circuit.
Applying a load on the piezo model, as I expect, high potential appears on a face and 0V to the opposite face.
Then I connected the piezo model with a circuit: with the External I vs U condition I realized a simple circuit with a resistor.
But in this way, the two surfaces of the piezo model go both to 0V and the current and the voltage across the resistor are 0.

I need help, thank you in advance!

Damiano

0 Replies Last Post 17 sept. 2012, 15:15 UTC−4
COMSOL Moderator

Hello Damiano Milani

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.