Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

two-phase flow in porous media

Seyed Mohammad Hossein Jazayeri Shoushtari

Please login with a confirmed email address before reporting spam

Hi,
I want to create a model for two-phase flow in porous media. I found an example in model gallery (Model ID:499) which is similar to my model (the example built in version 3.5a but my version is 4.3). I have built my own model like to this example but when I run my own model this error message appeared:

>>>> An attempt to evaluate a negative power of zero (you can see the full error message in the attached file)

I re-checked the expressions that mentioned in the error message but according to governing equation and these expressions we can not have any zeros in denominator anywhere.

I attached my model would you please have a look on that and guide me to overcome to this issue.

Cheers,
Amir


0 Replies Last Post 14 sept. 2012, 02:02 UTC−4
COMSOL Moderator

Hello Seyed Mohammad Hossein Jazayeri Shoushtari

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.