Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Finding insertion loss for SAW sensor

Posted 24 août 2022, 03:06 UTC−4 0 Replies

Rai Ram
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

Im trying to plot insertion loss using formula -20log10|Vin/Vout|. Im using time dependent analysis and then time to FFT for calculation of ouput voltage.

Im giving impulse voltage as said in the attached paper. i.e. Vin = 1V for 0<= t<=1ns and 0 V t>1ns for even input IDT. Odd input IDT kept ground. For output IDT kept floating potential.

Im using interpolation function to give input voltage condition and time step 1ns and total time 200ns. Im not able to get required insertion loss.

Please help me.

Thanks Rai

0 Replies Last Post 24 août 2022, 03:06 UTC−4
COMSOL Moderator

Hello Rai Ram

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content