Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
regarding capacitance of two square plates diaphragm made of silicon
Posted 3 août 2012, 00:18 UTC−4 MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 3.5a 1 Reply
Please login with a confirmed email address before reporting spam
how can i find the capacitance of two parallel square plates?
please tell the modules to be used in 3.5 a version.
in this case one plate is fixed(lower) & the four sides of upper plate is fixed which act as diapragm.
in 3.5a version, the capacitance is not defined in the predefined quantites, in electrostatics module.....
then how can i find the capacitance.................???????????
please tell the modules to be used in 3.5 a version.
in this case one plate is fixed(lower) & the four sides of upper plate is fixed which act as diapragm.
in 3.5a version, the capacitance is not defined in the predefined quantites, in electrostatics module.....
then how can i find the capacitance.................???????????
Attachments:
1 Reply Last Post 3 août 2012, 04:47 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
what about checking the doc and the model library, there are a fwe eaxmples therein, with step by step instructions. Not to say, try a search on the FORUM, uder 3.5a
--
Good luck
Ivar
what about checking the doc and the model library, there are a fwe eaxmples therein, with step by step instructions. Not to say, try a search on the FORUM, uder 3.5a
--
Good luck
Ivar