Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

3D coil modeling

Posted 8 avr. 2022, 00:01 UTC−4 1 Reply

LeShen Wg
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hello, everyone: When I model and simulate a three-dimensional coil in a magnetic field, how can I realize the series connection of multi-turn coils? thank you!

1 Reply Last Post 12 avr. 2022, 02:49 UTC−4
Mickaël Barsive COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 12 avr. 2022, 02:49 UTC−4
Updated: 3 years ago 12 avr. 2022, 11:06 UTC−4

Hello,

You could set the same current in both multiturn coils or use "Electric Circuit (cir)" interface to connect them.

If you need further assistance please contact COMSOL Technical Support here: https://www.comsol.com/support

Best regards,

Mickaël BARSIVE

Hello, You could set the same current in both multiturn coils or use "Electric Circuit (cir)" interface to connect them. If you need further assistance please contact COMSOL Technical Support here: https://www.comsol.com/support Best regards, Mickaël BARSIVE

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content