Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Create Plane through Partial Geometry

Posted 6 avr. 2022, 11:29 UTC−4 Low-Frequency Electromagnetics, Introduction, Results & Visualization 1 Reply

Felix Viet-Jacobsen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I'm trying to create a plane to create a surface average of current density.

A surface layer can only do the top and bottom layer, and a cut plane also includes the air domain beyond the sample, which I don't want.

How can I create a plane that only includes the sample, but can be placed at any depth within the sample? Please see images for explanation.

I hope this is clear, thank you!

  • Felix!

Attachments:

1 Reply Last Post 6 avr. 2022, 11:39 UTC−4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 6 avr. 2022, 11:39 UTC−4

Hi Felix,

There's an old thread for that.

Best,

Jeff

-------------------
Jeff Hiller
Hi Felix, There's an [old thread](https://www.comsol.com/forum/thread/265671/selecting-domains-for-plot-using-the-filter?last=2020-07-21T06:29:20Z) for that. Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content