Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problems with meshing or visualisation

Posted 10 juil. 2012, 06:55 UTC−4 Fluid & Heat, Microfluidics, Mesh, Results & Visualization, Studies & Solvers 0 Replies

Andreas Artelsmair
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I'm trying to simulate a lamminar mikrofluidics current. This simulations is to test how comsol can transfer solutions from a study 1 to a study 2. In the first Study I am using solid mechanics and need the deformed geometry for the fluid dynamics simulation in the second study. In the file below is the model. The resiult looks quite good, but the mesh is not deformed like it should be. Is this just a problem of the visualisation or went something wrong??

The next wuestion is what shall I do with a warning that says: Number of inverted elements: 3?? I get it in the simlation of the valve, when I mesh it!!

Thanks in advance,
Andreas
0 Replies Last Post 10 juil. 2012, 06:55 UTC−4
COMSOL Moderator

Hello Andreas Artelsmair

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content