Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

3D modeling of rotating rod in a cylindrical chamber

Posted 24 nov. 2021, 05:01 UTC−5 Computational Fluid Dynamics (CFD) 1 Reply

Amirreza Gholivand
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi All,

I want to simulate a chamber and a rod small rod rotates and generates flo of the fluid in the in the cylindrical chamber. I used rotating machinary for laminar flow but it is not possible to build initial values (only if i give zero for all initial values it start solving and give now flow however I expect flow).

1 Reply Last Post 24 nov. 2021, 07:01 UTC−5
Lasse Murtomäki
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 24 nov. 2021, 07:01 UTC−5

Look the rotating_disk tutorial model for comparison. It is under CFD --> Single-Phase flow.

Look the rotating_disk tutorial model for comparison. It is under CFD --> Single-Phase flow.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content