Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Load on Pressure sensor
Posted 3 juil. 2012, 16:09 UTC−4 Structural Mechanics Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I am modelling a piezo-resistive pressure sensor. In my model pressure is to be applied ONLY to the top surface of the structure. I am not sure if i have to apply the load as "Pressure" or as "Force per unit area" , under solid mechanics. I don't understand the difference between the two and need some clarification regarding which of the two options should be used.
Thanking you in advance,
Vijay
I am modelling a piezo-resistive pressure sensor. In my model pressure is to be applied ONLY to the top surface of the structure. I am not sure if i have to apply the load as "Pressure" or as "Force per unit area" , under solid mechanics. I don't understand the difference between the two and need some clarification regarding which of the two options should be used.
Thanking you in advance,
Vijay
1 Reply Last Post 4 juil. 2012, 01:45 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
Force per unit area can e defined in the different directions, as a vector, a pressure is always normal to the surface and is a scalar. But indeed both are defined as "pressures N/m^2. You have also total force, a scalar distributed EVENLY over the full boundary
--
Good luck
Ivar
Force per unit area can e defined in the different directions, as a vector, a pressure is always normal to the surface and is a scalar. But indeed both are defined as "pressures N/m^2. You have also total force, a scalar distributed EVENLY over the full boundary
--
Good luck
Ivar