Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Why arrow surface in cut plane is so different from volume arrow in 3d multislice?
Posted 11 oct. 2021, 09:54 UTC−4 Electromagnetics, Low-Frequency Electromagnetics Version 5.2 0 Replies
Please login with a confirmed email address before reporting spam
Hello, I have a question about "arrow surface in cut plane".
Isn't arrow surface in cut plane( In my case, I chose yz plane of cylinder) equal arrow volume in multislice, yz plane? I asked this because In 3d simulation, volume arrows in yz plane observed like they are going down, but in 2d plot, they aren't going down!
I think arrow volume in 3d multislice plot (only at yz plane) and surface arrow in yz plane(2d plot) should be same.
Can you tell me why they are different?
Thank you in advance. Yunseo
Hello
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.