Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Micropump Simulation

Posted 21 juin 2012, 12:17 UTC−4 Fluid & Heat, Results & Visualization, Structural Mechanics 2 Replies

Mychal Smith
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am simulating a micropump. The top layer of material is PDMS, which has a load applied that corresponds to 10 psi. The right and left boundaries are constrained so that they cannot move. The middle layer is water, and the bottom layer is steel, which is constrained by all 4 boundaries. The idea is when the PDMS is deflected using a time varying load, the water flow is suppose to be affected. However, I cant get the moving layer of PDMS and the water to simulate at the same time during the animation.

Any ideas of how to get them to work together and show at the same time? I've attached the file below.

Attachments:

2 Replies Last Post 25 juin 2012, 11:21 UTC−4
Xsu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 25 juin 2012, 00:07 UTC−4
I also having the same problem, I think that is the limitation for old version.
Are you simulated in 3-D?

Regards,
PS
I also having the same problem, I think that is the limitation for old version. Are you simulated in 3-D? Regards, PS
Mychal Smith
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 25 juin 2012, 11:21 UTC−4
Mine is actually 2D. I think you may be right. It solves perfectly fine and displays each surface plot correctly, just separately
Mine is actually 2D. I think you may be right. It solves perfectly fine and displays each surface plot correctly, just separately

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content