Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Periodic Boundaries in 3D :: # of Vertices Needed?

Posted 19 juin 2012, 12:18 UTC−4 1 Reply

Chris Layman
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

Question: When mapping source vertices to destination vertices of a boundary in 3D is it sufficient to only map 3 vertices of boundary that has has more than 3?

Thanks in advance ~
1 Reply Last Post 19 juin 2012, 16:08 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 19 juin 2012, 16:08 UTC−4
Hi

normally for a 2D to 2D mapping you need 3 vertices, origine, X-direction, Y-direction, for full 3D you need the last Z-direction hence a 4th vertex

--
Good luck
Ivar
Hi normally for a 2D to 2D mapping you need 3 vertices, origine, X-direction, Y-direction, for full 3D you need the last Z-direction hence a 4th vertex -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content