Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Align the surface tangentvector to the centerline of geometry

Please login with a confirmed email address before reporting spam

Hello, I'm working with comsol for my bachelor thesis in CFD and I'm trying to adjust the tangent vectors on the surface of my geometry (a vessel) in the direction of the stream , because Comsol spitting out a very "wild" varieations of tangent vectors (axial). To do so i try to align my tangent vectors with the centerline of my geometry which i created with a interpolation curve. How do I get this alignment?! The basis of my consideration is a small part in a paper i put in in the attachment. There is a description of how to chose the tangent vectors. Probably that helps. I hope there are some thougts you can share.

Tristan



0 Replies Last Post 28 juil. 2021, 06:48 UTC−4
COMSOL Moderator

Hello Tristan Probst

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.