Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to visually observe point of singularities in the post processing step
Posted 16 juin 2021, 11:22 UTC−4 Microfluidics, Chemical Reaction Engineering, Equation-Based Modeling Version 5.6 0 Replies
Please login with a confirmed email address before reporting spam
Hi All, This is a follow up to my previous post here
I have tried to define point sinks in the geometry. From what I understand the positions at which the point sinks are defined will act as point of singularity since the solution will tend toward infinity. Please correct me if I am wrong. However, I am not able to observe this in the results - concentration vs. plot that is generated.
I would like to know how this can be visually observed. result.
I expect that the solution curve will dip to infinity and one would observe sharp peaks (like shown in the gif attached in this post www.comsol.co.in/forum/thread/130441/wave-equation-singularities-at-the-source-point). But I am not sure why this isn't observed in my solution curves.
Suggestions will be really helpful.
Hello Deepa
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.