Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Work Plane: plane alignment

Posted 25 avr. 2012, 01:17 UTC−4 3 Replies

Marcus Mesentosch
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello!

I'm going through the "Introduction to Comsol Multiphysics®" Tutorial and I have question concerning the work plane.
When you create a work plane, you can chose a plane alignment, for example xz-plane.
The tutorial from page 66 shows how to draw the busbar geometry. A xz-plane is selected. Now I do not understand why later you draw on the xy-plane? I've made to screenshots to show you my problem. As you can see I've created a xz-plane but I'm still drawing on the the xy-plane.

Attachments:

3 Replies Last Post 26 avr. 2012, 08:56 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 25 avr. 2012, 03:16 UTC−4
Hi

I do not really understand, I see a X-Z plane and drawings on the X-Z plane ;)

--
Good luck
Ivar
Hi I do not really understand, I see a X-Z plane and drawings on the X-Z plane ;) -- Good luck Ivar
Marcus Mesentosch
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 26 avr. 2012, 00:30 UTC−4
There is a second coordinate system, which I've never defined.
There is a second coordinate system, which I've never defined.
Dennis Brown
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 26 avr. 2012, 08:56 UTC−4
The modeling starts off with using the xz plane where you draw the 2D profile of the busbar. Then you extrude that profile to a 3D rendering in the y direction. If you look in the model library example there are two more workplanes used for drawing the bolt holes. Those workplanes are "face parallel" orientation. Technically the last workplane in the geometry buildup is in the xy plane where you add the two bolt holes. Doing face parallel orientations makes it easier to locate new objects w/o having to determine exact heights/depths/widths of your object. Pay attention to the orientation x,y,z indicator in comsol as it tells you where you are at in the geometry.
The modeling starts off with using the xz plane where you draw the 2D profile of the busbar. Then you extrude that profile to a 3D rendering in the y direction. If you look in the model library example there are two more workplanes used for drawing the bolt holes. Those workplanes are "face parallel" orientation. Technically the last workplane in the geometry buildup is in the xy plane where you add the two bolt holes. Doing face parallel orientations makes it easier to locate new objects w/o having to determine exact heights/depths/widths of your object. Pay attention to the orientation x,y,z indicator in comsol as it tells you where you are at in the geometry.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content