Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Baw Resonator Problem

Posted 19 avr. 2012, 08:03 UTC−4 MEMS & Nanotechnology, Acoustics & Vibrations, MEMS & Piezoelectric Devices Version 4.2, Version 4.3a 3 Replies

Vineet
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam


Hi
I am working on a baw resonator. For our simulation we have considered a 3.5a COMSOL 2D model of Thin Film Bulk Acoustic Wave Resonator in the model archives of COMSOL.

So we treid to simulate the 3d model in 4.2 but so far we are not able to achieve any displacement and correct results.We were struggling with the meshing earlier but we adopted swept mesh with tri and tetra for our model.

Our Model consist of 4 thin layers of diferent materials and we want to obtain freq. response on the aplication of the voltage.


Please inform us about the ambiguities and errors in our model so that we can conclude our research.

Thank You
--
Vineet Bansal
Project Associate, NPMASS
Electronic Science Department
Kurukshetra University, Haryana

Attachments:

3 Replies Last Post 4 déc. 2013, 10:24 UTC−5
COMSOL Moderator

Hello Vineet

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Vidya Shree Niranjan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 18 déc. 2012, 09:55 UTC−5
Hi,
I am trying to develop a BAW resonator model. Can anyone help me how to develop this model using version 4.2. which all the physics i must use.
Hi, I am trying to develop a BAW resonator model. Can anyone help me how to develop this model using version 4.2. which all the physics i must use.
Pham Huan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 8 juil. 2013, 03:25 UTC−4
I downloaded your model and runned in comsol 4.3, it take some time but finally it gaved me result. those the result is not beatiful but there is not any problem happen at all. please check with comsol 4.3 version.
Best regard.
I downloaded your model and runned in comsol 4.3, it take some time but finally it gaved me result. those the result is not beatiful but there is not any problem happen at all. please check with comsol 4.3 version. Best regard.
Simon Schwarz
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 4 déc. 2013, 10:24 UTC−5
Did you manage to get the frequency response of ur 3D model? I have been trying it for a couple of months and didn't get any result. Could you guide me or provide me any help?
I will thank you a lot!
Did you manage to get the frequency response of ur 3D model? I have been trying it for a couple of months and didn't get any result. Could you guide me or provide me any help? I will thank you a lot!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content