Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Geometry from autocad

Posted 22 janv. 2021, 09:26 UTC−5 General, Introduction, Modeling Tools & Definitions Version 5.5 0 Replies

Maksim Sitnikov Doctoral Researcher
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello! I'm new to the COMSOL, could you please tell me how to set the geometry imported from AutoCAD to the origin? in my case, it moves and, accordingly, then it is quite difficult to adjust the rotating parts

0 Replies Last Post 22 janv. 2021, 09:26 UTC−5
COMSOL Moderator

Hello Maksim Sitnikov

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content