Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to control the flux density waveform in time-dependent magnetic field simulation

Posted 23 nov. 2020, 05:04 UTC−5 Low-Frequency Electromagnetics, General 0 Replies

Shuaichao Yue
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am now conducting magnetic field simulation for a electrical steel sheet . How can I get a desired flux density waveform inside the sheet cross (average B)? For now, I apply experimental current waveform into the coil but the generated B inside the sample sheet is unpredictable. Does anyone know how to get a desired B waveform inside the sample?

SC Yue

0 Replies Last Post 23 nov. 2020, 05:04 UTC−5
COMSOL Moderator

Hello Shuaichao Yue

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content