Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Content is not allowed in prolog

Posted 13 juin 2020, 13:22 UTC−4 General Version 5.4 0 Replies

Sinéad Mannion Plasma Physics
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello Comsolers!

I foolishly ran an very long simulation and got an Out of Memory error. I edited the comsol.ini file as in the support below. https://www.comsol.com/support/knowledgebase/1243

When I try to save and open, or save as the recovery file I get Content is not allowed in prolog error!

Any ideas of how I can overcome this? I cannot open the recovery file at all.

Kindest regards,

Sinéad

0 Replies Last Post 13 juin 2020, 13:22 UTC−4
COMSOL Moderator

Hello Sinéad Mannion

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content