Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modelling Magnetic Field Outside Inductor Component

Posted 5 juin 2020, 11:56 UTC−4 Electromagnetics, Low-Frequency Electromagnetics, RF & Microwave Engineering 0 Replies

NV C
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I have an inductor acting as an antenna that I would like to model the magnetic field around it. I have attached a picture below. I tried following the dipole tutorial, but got confused with how I would be adding the voltage input at the ends of the wires.

Here is my wire the wire for my inductor

Thank you!

0 Replies Last Post 5 juin 2020, 11:56 UTC−4
COMSOL Moderator

Hello NV C

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content