Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Reset History Error: The variable names must be unique

Posted 1 févr. 2012, 15:42 UTC−5 Version 4.2a 1 Reply

Chien Liu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

How do I go about finding the non-unique variable names???
1 Reply Last Post 2 févr. 2012, 01:44 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2 févr. 2012, 01:44 UTC−5
Hi

if you have no other message its not obvious ;)

Most single letter variable names are already used by COMSOL and often you get no early warning, as COMSOL allows you to redefine a variable, but you must know what you are doing as else you get bizarre errors

Check your Parameters and Variable definitions, and try to use longer names

--
Good luck
Ivar
Hi if you have no other message its not obvious ;) Most single letter variable names are already used by COMSOL and often you get no early warning, as COMSOL allows you to redefine a variable, but you must know what you are doing as else you get bizarre errors Check your Parameters and Variable definitions, and try to use longer names -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content