Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Resuming a simulation from a previous run at a time the solver could not converge
Posted 1 mai 2020, 18:09 UTC−4 General, Computational Fluid Dynamics (CFD), Studies & Solvers Version 5.5 0 Replies
Please login with a confirmed email address before reporting spam
I was running a simulation a 2D axisymmetric plasma DC discharge. Unfortunately, after 2 days of ruuning, at one of the time intervals, the simulation stopped with the following error:
"Nonlinear solver did not converge. Maximum number of Newton iterations reached. Time: 2.4364424006683502e-06 s. Last time step is not converged."
Is there any way I can resume my simulation from the aforementioned time interval (2.43E-6s) onwards?
N.B. I tried creating a new study starting from 2.43E-6 s by taking initial conditions from the previous study (that crashed out) at that particular time but it did not seem to give dependable results.
-------------------Thanking you,
-Malik M Tahiyat
Graduate Research Assistant,
Department of Mechanical Engineering
University of South Carolina (USC)
300 Main Street, Room A 137
Phone: +1(803)-318-0274
Hello Malik M Tahiyat
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.