Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Determining area and volume of axis-symmetric object

Posted 20 janv. 2012, 05:02 UTC−5 Results & Visualization, Structural Mechanics Version 4.2a 2 Replies

Christian Kelb
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi!

I'm modeling a membrane as an axis-symmetric object. Can you tell me how I can determine the area and the volume of the upper side of the deflected membrane?

I understand there have to be integration-nodes for this tasks in the postprocessing. But where?

Best regards,
Christian Kelb

Attachments:

2 Replies Last Post 20 janv. 2012, 17:01 UTC−5
Pranay Ghosh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 janv. 2012, 09:37 UTC−5
you can take the volume integration with parameter as 1 with dataset "revolution" 0 to 360 to get the volume
you can take the volume integration with parameter as 1 with dataset "revolution" 0 to 360 to get the volume
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 janv. 2012, 17:01 UTC−5
Hi

in 2D axis-symmetry, when you integrate over an edge and use the integrand 2*pi*r you get the revolved surface, but if you define your integration operator, you can check the surface to volume box, then the 2*pi*r are automatically added. Check the units to be sure you have it right.

There are several threads on the forum about this

--
Good luck
Ivar
Hi in 2D axis-symmetry, when you integrate over an edge and use the integrand 2*pi*r you get the revolved surface, but if you define your integration operator, you can check the surface to volume box, then the 2*pi*r are automatically added. Check the units to be sure you have it right. There are several threads on the forum about this -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content