Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simulate with imported mesh

Posted 25 janv. 2020, 13:38 UTC−5 General, Geometry, Mesh 0 Replies

晟 潘
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I have a .nas format imported to comsol as mesh. However, when I create geometry from imported mesh, another component is created. I wonder wether it is possible to create geometry with imported mesh in one component so that simulation can be run on it. I will be very grateful for your guide.

0 Replies Last Post 25 janv. 2020, 13:38 UTC−5
COMSOL Moderator

Hello 晟 潘

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content