Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Static Deflection Modeling of 3d Printed Structures
Posted 10 janv. 2020, 09:04 UTC−5 Structural & Acoustics Version 5.5 0 Replies
Please login with a confirmed email address before reporting spam
Does anyone have experience modeling the static deflection of 3d printed structures, in particular if the infill is not 100%? The simplest example would be the deflection of a flat 3d printed plate simply supported at each end with a point load at the center. If the infill is 100%, does anyone have experience with how this compares to just a solid cantilever of PLA material? The attached photo shows it printing a simple cantilever with 20% infill. Do you think it would give reasonable results if this was modeled as a flat upper/lower plate with a rectangular grid inside? If anyone has experience with this, I would appreciate feedback before trying more complicated shaped structures that would take more effort to define the geometry.
Thanks, Tom
Attachments:
Hello Thomas Huber
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.