Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
need guidance on setting up block model
Posted 9 janv. 2020, 02:19 UTC−5 Electromagnetics, Low-Frequency Electromagnetics 0 Replies
Please login with a confirmed email address before reporting spam
Hi all,
I am facing some difficulties in establishing my own block model. I have check the application gallery to see if there is similar existing projects that I can adopt.
Upon looking through all the electrical application, I realised my project is similar to the "Cable Tutorial Series" (https://uk.comsol.com/model/cable-tutorial-series-43431), however, the model shown in the gallery is 3 core XLPE cable with armoured, my application is single core XLPE cable with armoured. I have tried deleting some of the "rotate" in geometry section. however, it will mess up the calculation of the application.
In that case, how can I create a single core, XLPE armoured or non-armoured cable? the material, layers and the current rating is the same as the existing application shown in gallery.
Need some guidance please as I have been attempting on this for a few days..
Hello Chun Kit Choi
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.