Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simulation of a tandem solar cell (I-V curve)

Please login with a confirmed email address before reporting spam

Hello everyone,

I'm trying to simulate a multi-junction solar cell in 1D. First, I have simulated the three subcells individually and obtained their I-V curves. Everything was ok, both short-circuit (Isc) and open-circuit voltage (Voc) were correct for the three of them. Then, I tried to simulate the top, middle and bottom subcells altogether, forming the whole solar cell. It was expected that the Voc would be more or less the sum of the all subcells' Voc, but that didn't happen. I really don't understand why this happens. Can someone help me?

In attachment are the I-V curves of each subcell (exported to MATLAB) and the obtained I-V curve of the whole solar cell.

Thank you very much, Sara Bernardes



0 Replies Last Post 3 nov. 2019, 15:21 UTC−5
COMSOL Moderator

Hello Sara Bernardes

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.