Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Is it possible to have a symmetry along pipes when using Pipe Flow Module?
Posted 5 avr. 2019, 16:21 UTC−4 Geomechanics, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD) 0 Replies
Please login with a confirmed email address before reporting spam
Hi all, I'm making a model of u-tube inside a cylinder by using Pipe Flow Module. The model is symmetric along the cylinder and tube length, but I could not make the symmtry BC to include the pipe (because it is lines in 3D). Thanks for your help.
Hello Ahmad Aljabr
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.