Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modeling Fluid flow with Impurities without using Moving Mesh

Posted 30 sept. 2011, 07:19 UTC−4 Fluid & Heat, Computational Fluid Dynamics (CFD), Materials, Mesh Version 4.2 0 Replies

Irfan Malik
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All ,

I want to simulate flow in a Channel (Length 10 cm) where I also have solid cubical particles( 1x1x1 cubic micrometer) already present inside the fluid. These particles are 45% of volume as compared to fluid.

I dont want to use Moving mesh approach .Is there a possibility to introduce the solid partciles as a Material ,instead of at the Geometry level .

I would appreciate the help.

Irfan.
0 Replies Last Post 30 sept. 2011, 07:19 UTC−4
COMSOL Moderator

Hello Irfan Malik

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content