Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to calculate the area variation of a 2D model in comsol 4.1?
Posted 12 sept. 2011, 23:19 UTC−4 Results & Visualization Version 4.1 1 Reply
Please login with a confirmed email address before reporting spam
Hi everyone
I constructed a simple 2D model which is a square plate and I used eigenfrequency solver to find its resonant modes. I found the area of the plate changes significantly when resonating. Now I want to to calculate the area variation of this square plate, but I do not know how. Could anyone help me? Thanks.
James
I constructed a simple 2D model which is a square plate and I used eigenfrequency solver to find its resonant modes. I found the area of the plate changes significantly when resonating. Now I want to to calculate the area variation of this square plate, but I do not know how. Could anyone help me? Thanks.
James
Attachments:
1 Reply Last Post 19 sept. 2011, 06:00 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
you should be aware that the deformations for eigenfrequency analysis are arbitrary, there is nothing limiting the amplitude (by design = definition of the eigenfrequency analysis) so these displacements (hence volume variations) are normalised in different ways. check the solver node you can use rms, mass matrix and other ways.
There are several threads about this on the forum, try a search
finally in structural, take car with respect to which FRAME you use for the integration
--
Good luck
Ivar
you should be aware that the deformations for eigenfrequency analysis are arbitrary, there is nothing limiting the amplitude (by design = definition of the eigenfrequency analysis) so these displacements (hence volume variations) are normalised in different ways. check the solver node you can use rms, mass matrix and other ways.
There are several threads about this on the forum, try a search
finally in structural, take car with respect to which FRAME you use for the integration
--
Good luck
Ivar