Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Spiral Induction Coil Geometry Issue

Posted 21 déc. 2018, 10:30 UTC−5 Electromagnetic Heating, Low-Frequency Electromagnetics, Geometry Version 5.3a 0 Replies

Matthew Roberts
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello All,

I have been attempting to make a spiral coil for a simple induction heating simulation. To make the coil, I have swept a circle along a parametric curve (an Archimedes spiral). However, when the sweep reaches the end of the curve, the circle ends up slightly rotated from how it began and I cannot close my geometry. In the attached image ("Coil Zoom") the bottom piece is the coil with its end at a small angle of rotation and the top piece is what I am attempting to connect it with.

Is there any simple way to force these geometries together? It seems like I am able to use the "Collapse Faces" command to the right of the centerline as the geometries are overlapping but I cannot easily close the gap seen on the left-hand side.

Thanks.

Matt

Attachments:

0 Replies Last Post 21 déc. 2018, 10:30 UTC−5
COMSOL Moderator

Hello Matthew Roberts

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content