Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to model the radiative heat source on a mirror

Posted 15 déc. 2009, 08:13 UTC−5 Wave Optics, Heat Transfer & Phase Change 1 Reply

Simon True
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi I am trying to study the temperature distribution of a mirror that is exposed to the intense laser radiations. The incident laser flux on the mirror is about 10 kW. The reflectance of the mirror is about 99.8%. The light absorption takes place only within a very thin Al layer ( about 0.1micron). Which means the heat source is not distributed throughout the mirror volume unlike the cases discussed in some of the models library examples (" laser heating of the skin tissue") in COMSOL. In other words, mirror substrate (1cm thick) is heated through the heat transfer from the surface heating of the reflecting layer by laser radiations.

My question is how to specify the boundary condition for radiative flux which goes in heating the sample? Can I put the Heat Source Q=0 in the subdomain setting and instead specify only the heat flux q0 on Al boundary?
I would greatly appreciate your response/comment/corrections.

-Sim
1 Reply Last Post 6 juil. 2011, 14:26 UTC−4
COMSOL Moderator

Hello Simon True

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

N Far
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 6 juil. 2011, 14:26 UTC−4
Did you ever find a solution to this problem? I am curious on how you did this.
Did you ever find a solution to this problem? I am curious on how you did this.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content