Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Concentration Source Term in Wrong Units?

Please login with a confirmed email address before reporting spam

Hello,

I'm trying to set up a 1d, axisymetric, reaction-diffusion problem.

I'm using 'coeffecient form' of the PDE

My dependent variable in concentration in [mol/m^3]

My source term should be a concentration addition rate in [mol/m^3-s], but I don't see it listed.

If I use the existing concentration in [mol/m^3] as my source term, my diffusion coeffecient ends up in the wrong units as [m^2]. My diffusion coeffecient is in [m^2/s].

How do I get this equation in terms of rates?


1 Reply Last Post 15 nov. 2018, 14:03 UTC−5
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 15 nov. 2018, 14:03 UTC−5
Updated: 6 years ago 15 nov. 2018, 14:09 UTC−5

Could the issue be that your model is stationary as opposed to time-dependent, and therefore time is not defined?

Jeff

-------------------
Jeff Hiller
Could the issue be that your model is stationary as opposed to time-dependent, and therefore time is not defined? Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.