Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
My Apologies: Laminar Flow and Transport
Posted 20 juil. 2011, 15:43 UTC−4 Fluid & Heat, Microfluidics Version 4.2 2 Replies
Please login with a confirmed email address before reporting spam
Help with a model combining laminar flow of a fluid and diffusion
Hello everyone, I am currently working with a basic transport model. It is composed of two gases flowing through two micro-channels in a block of PDMS. Modeling diffusion is my goal, any advice?
I know the diffusion coeficients for N2 and O2 diffusing into the PDMS; however, I do not know the Dij for O2 diffusing into N2 as they both diffuse into the PDMS. In addition, the volumetric flow-rate of N2 is 10 to 20 times that of O2. I determined the flux from the equations in Perry's but I am not sure that the model is set up right. Thanks and have great day!
I had some difficulties attaching my model and a visio schematic. Here is the mph file.
Any help would be greatly appreciated.
Kind regards, Steve
Hello everyone, I am currently working with a basic transport model. It is composed of two gases flowing through two micro-channels in a block of PDMS. Modeling diffusion is my goal, any advice?
I know the diffusion coeficients for N2 and O2 diffusing into the PDMS; however, I do not know the Dij for O2 diffusing into N2 as they both diffuse into the PDMS. In addition, the volumetric flow-rate of N2 is 10 to 20 times that of O2. I determined the flux from the equations in Perry's but I am not sure that the model is set up right. Thanks and have great day!
I had some difficulties attaching my model and a visio schematic. Here is the mph file.
Any help would be greatly appreciated.
Kind regards, Steve
2 Replies Last Post 10 oct. 2011, 20:03 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
just saying there is an "edit" button at the bottom of the post, to avoid the multiple thread thing if you forget something .....
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thank you, friend. I realized this after I decreased the window 'view' from 100 to 90 percent which allowed the edit button to be in view. I was able to solve the model with some help from the kind folks in Ohio. The key was solving the laminar flow physics first (using fine mesh structures) and then coupling those physics with the diffusion physics. Instead of utilizing Fickian diffusion, I used Maxwell-Stephan diffusion, because it was closer to a more realistic model. Currently, I am preparing to build the actual micro-fluidic chip in the laboratory. It is exciting!
Thank you and kind regards,
Steven
Thank you and kind regards,
Steven