Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boolean Geometry Operation Failed

Please login with a confirmed email address before reporting spam

I'm getting the following error message when I try to mesh a toroidal inductor with a rectangular cross-section, imported from an external CAD software: "Boolean Geometry Operation Failed" (it is a very complicated model as it is many-turned and tries to approximate a geometrically thin wire). Can anyone explain what the most likely fix is, or where I can look to try to successfully mesh my model?

I can provide any pictures or files if it would make my question a bit clearer.

-Thanks, Henry


0 Replies Last Post 22 août 2018, 21:55 UTC−4
COMSOL Moderator

Hello Henry Froland

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.