Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Parameter sweep over geometrically decreasing mesh and material property

Please login with a confirmed email address before reporting spam

The below post is related to an archived discussion


There were earlier discussions on a parametric sweep of geometry. I did this using a range function in COMSOL which allows a discrete change in a parameter value. Suppose instead of a uniform discrete change, I want a geometric discrete change in my mesh size and a material property in my parametric sweep. How might I do this?


0 Replies Last Post 16 août 2018, 19:01 UTC−4
COMSOL Moderator

Hello Cael Warner

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.