Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

contact problem flat-flat

Please login with a confirmed email address before reporting spam

hi all,
right now i am working in modeling of pentrating a plat by stainless steel probe, and i am trying to do that for different probe tip shapes
but i faced a problem with the parameteric analysis of contact surface; the simulation faild at the begining of the running, I have attached my program.
looking for your help


0 Replies Last Post 7 déc. 2009, 14:24 UTC−5
COMSOL Moderator

Hello ali olamat

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.