Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2D Heat Transfer question regarding temperature obtained in graph

Posted 19 mai 2011, 10:29 UTC−4 Heat Transfer & Phase Change, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers Version 4.1 1 Reply

James Compagnoni
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everyone,

I've created a 2D model of a device dissipating ~1.7e9 W of power per cubic meter which is embedded in FR4 material. I followed very closely the instructions of the model documentation on natural convection of a vertical circuit board, including keeping the buoyancy term which accounts for density fluctuation as the air heats up.

In addition to embedding the device in the substrate, I have also made the whole structure horizontal by rotating it (done easily) and then attaching a 50 micon thick copper plane on the whole top surface of the device and substrate to see how that affects the temperature distribution as well as max temperature.

What I don't understand is the lower bounded temperature that I am receiving in my results-- near -29.2 degC. I find this strange because my inlet temperature is room temperature for the air.

Any thoughts would be greatly appreciated! I have attached the file for convenience as well as in case I have not explained something well.

Regards,
James
1 Reply Last Post 19 mai 2011, 10:47 UTC−4
James Compagnoni
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 19 mai 2011, 10:47 UTC−4
Also,

When I add copper vias under the power device as well as attached to the copper plane on the top surface, the default solver (I tried the direct solver as well) does not solve it. It returns with an error:

Failed to find a solution.
Maximum number of Newton iterations reached.
Returned solution has not converged.

Any advice as to how I can fix this? I presume my initial/boundary conditions are the culprit but I don't know what to do. The file is attached for convenience.

Thanks much!

James
Also, When I add copper vias under the power device as well as attached to the copper plane on the top surface, the default solver (I tried the direct solver as well) does not solve it. It returns with an error: Failed to find a solution. Maximum number of Newton iterations reached. Returned solution has not converged. Any advice as to how I can fix this? I presume my initial/boundary conditions are the culprit but I don't know what to do. The file is attached for convenience. Thanks much! James

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content