Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
how to refer to another point or boundary?
Posted 5 mai 2011, 11:24 UTC−4 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I would like to define the boundary condition of a point (corner) on geometry such that to be dependent on the value of another point. I am using Structural Mechanics application, and to my knowledge, this cannot be done in COMSOL's GUI, because the constraints for the nodes should be defined as displacements (Rx & Ry in 2D) and there is no point index to refer to.
So I decided to create the m file and use it in MATLAB. My m file has about 33000 lines, although my geometry is a 4-corner plane solid. I could not figure out how index of a point (e.g. pnt.ind=[1,2,2,1]) can be addressed and used somewhere else in the file. Also, I do not know why some of these command lines are repeated in the m file.
Any hint is appreciated.
Thanks,
Manuel.
I would like to define the boundary condition of a point (corner) on geometry such that to be dependent on the value of another point. I am using Structural Mechanics application, and to my knowledge, this cannot be done in COMSOL's GUI, because the constraints for the nodes should be defined as displacements (Rx & Ry in 2D) and there is no point index to refer to.
So I decided to create the m file and use it in MATLAB. My m file has about 33000 lines, although my geometry is a 4-corner plane solid. I could not figure out how index of a point (e.g. pnt.ind=[1,2,2,1]) can be addressed and used somewhere else in the file. Also, I do not know why some of these command lines are repeated in the m file.
Any hint is appreciated.
Thanks,
Manuel.
1 Reply Last Post 5 mai 2011, 15:15 UTC−4