Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

boundary condition

Posted 4 mai 2011, 03:38 UTC−4 1 Reply

Amira El-Sayed
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,
in 2D stationary PDE
if i put the initial value of u=10 (for example) at certain boundary.
After solution
when calculate u at this boundary I don't find it 10 but a value near it?
Regards
1 Reply Last Post 4 mai 2011, 09:46 UTC−4
Yaseen Al Waaly
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 4 mai 2011, 09:46 UTC−4
Hi
You are applying the boundary condition normal to the boundary ( 1D) and comsol showing you the calculated boundary, i.e., check the normal value to your boundary, you will find the applied value.
Hi You are applying the boundary condition normal to the boundary ( 1D) and comsol showing you the calculated boundary, i.e., check the normal value to your boundary, you will find the applied value.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content