Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Periodic boundary Conditions( can I use two PBCs instead of 4 in 3D structure?)
Posted 10 mai 2018, 06:39 UTC−4 0 Replies
Please login with a confirmed email address before reporting spam
Dear Comsol Team, Greetings from Sydney.
I'm modeling an absorber with RF module, EMW using PBsC. My goal is to match my measured results to the simulation ones. My question is if it is possible to use two PBCs ( master and slave) in two side, while leaving the other 2 sides PEC by default? I am asking this, because, when I use 4 PBCs, the results are not matching and look very ugly, but with 2 PBCs, the results are quite better and close to the experimental one. But I am not sure if this is correct. Thank you so much for your usual good cooperation.
Yours faithfully, Patrick
Hello Patrick R
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.