Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Thermal stabilisation in COMSOL

Posted 22 mars 2018, 04:54 UTC−4 General, Heat Transfer & Phase Change 1 Reply

Andrea Alippi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I'm trying to built a model of a temperature stabilized microsystem.

The attachment is a simplified version of the model I'm trying to build. It has an constant temperature of 20 degC on the left boundary and on the right boundary a virable heat flux defined by some equation, lets say flux = 100* X.

I want COMSOL to find the value of X where the temperature on the interface is equal to lets say 50 degC. How would I go about doing this.

Thanks in advance, Andrea

Attachments:

1 Reply Last Post 26 mars 2018, 02:21 UTC−4
François Mandias COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 26 mars 2018, 02:21 UTC−4

Hi Andrea,

I suggest you send your post directly to: support@comsol.com

Kind regards, François

Hi Andrea, I suggest you send your post directly to: support@comsol.com Kind regards, François

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content